REPLACEMENT LOG SET
INSTALLATION INSTRUCTIONS
FOR BTB18, BTB24, PDG18 AND PDG24 GAS LOG HEATERS
3. Place new log set assembly over chassis and align holes on
WARNING: If log set has been in use, make sure
control knob is in the OFF position, unit is cold and
gas has been turned off.
bracket with holes on chassis (see Figure 2).
4. Replace six screws removed in step 1.
Part No.
Description
Qty.
1
111835-01
111834-01
111827-01
111802-01
111817-08
111824-01
Replacement Log Set 18'' - BTB18
Replacement Log Set 18'' - PDG18
Replacement Log Set 24'' - BTB24
Replacement Log Set 24'' - PDG24
Flex Tube
1
1
1
1
Compression Nut/Sleeve
2
Your replacement kit will contain only one log set assembly depend-
ing on your model. If there is a problem with your replacement log
set contact the authorized dealer where you bought the set or FMI
PRODUCTS, LLC at 1-866-4537.
Bracket
Items Needed for Installation:
•
•
•
5/16'' Hex Socket Wrench or Nut Driver
Phillips Screwdriver
5/8'' Wrench or Adjustable Wrench
24" Set
Chassis
1. Remove six screws from sides of log set assembly (three on
each side). Remove log set assembly (see Figure 1). Do not
pull on log assembly to remove. Work log set off chassis by
manipulating metal base.
2. 18'' models only: Disconnect flexible gas line from valve and
burner (see Figure 1). Discard flex line.
Bracket
Chassis
18" Set
Disconnect
Flexible Gas Line
24" Set
18" Set
Figure 1 - Removing Log Set
Figure 2 - Installing Replacement Log Set
Save these instructions for future reference
|